Global Mills (Directions)
|
Driving directions are no longer maintained.
This page about Global Mills is now obsolete. It is part of a wiki project that was active during 2020/2021. Since 2022, driving directions are being replaced by location descriptions on city pages. For more information, see:
|
Global Mills has processing plants in Colorado, New Mexico, Oregon, Utah, and Washington.
How to find us:
Albuquerque, NM
From I-25 take exit 228, and head West. Turn right at the second light and continue straight to our facility.
Billings, MT
- ⚠️ The directions in this section need verification.
On MT 3, turn left and right.
Bozeman, MT
- ⚠️ The directions in this section need verification.
On Interstate 90 Business, turn right, then left. Two entrances to depot are here: west and northeast entrance.
Cedar City, UT
From I-15 take exit 57 and head West towards Cross Hollow. Continue West until you cross the tracks and turn right onto UT-56. Take the next right to enter our facility.
Clovis, NM
From US-60 at US-70 junction turn right and head West. Take the second right and out facility is on the left.
From US-70 make the left at the Clovis city limit sign.
Glasgow, MT
- ⚠️ The directions in this section need verification.
On US 2, turn right and right through Avalanche Steel. Entrance in a left road.
Glendive, MT
- ⚠️ The directions in this section need verification.
On MT 16, after passing gas station with a weigh station, turn right.
Havre, MT
- ⚠️ The directions in this section need verification.
Grain elevator is located in Havre North. Turn left in S-232 that connects suburb with Havre in south.
Ontario, OR
Take exit 376A (Ontario) from I-84 and turn onto US-30 Bus. West. Then, turn right after the gas station to reach our facility.
From Burns, OR on route 20: Continue straight ahead on OR-201 bypassing the city center before turning right to join I-84 South, then proceed as above.
Roswell, NM
We are located South of Roswell on US-285. Go South from the US-285/380 junction, heading out of town turn left at the Supermarket Plaza and then right.
Sidney, MT
- ⚠️ The directions in this section need verification.
On MT 16, after passing Farmer's Barn, turn right.
Sterling, CO
From I-76 take exit 125 and head towards Sterling. Turn left onto Fourth St at the third light and continue through town. Once you cross the railroad tracks our facility will be on the right.