Avalanche Steel (Directions)
|
Driving directions are no longer maintained.
This page about Avalanche Steel is now obsolete. It is part of a wiki project that was active during 2020/2021. Since 2022, driving directions are being replaced by location descriptions on city pages. For more information, see:
|
Avalanche Steel has facilities throughout the Pacific Northwest and Rocky Mountains.
How to find us:
Alamosa, CO
Cheyenne, WY
Take I-180/US-85 and turn West at 9th Street, then follow the signed truck route to Avalanche Steel.
Coeur d'Alene, ID
Take exit 11 on I-90 and head North toward Ramsey Road. Take the first right, left, and right.
Everett, WA
From I-5 heading North take exit 193 head towards Everett City Center. Turn left at the stop sign, at the light turn right. Turn left onto Everett Ave, then right onto Broadway. Stay right towards Marysville then immediate exit left and head back towards Everett. Once you cross the bridges our entrance will be on the right.
From US-2 follow toward Everett and turn right at the T intersection. Then left onto Broadway. Follow directions above.
From I-5 heading South take exit 198, once you cross the bridges our entrance will be on the right.
Fort Collins, CO
Glasgow, MT
- ⚠️ The directions in this section need verification.
Run through US 2 near Tidbit market, then turn right. The scrapyard is located near Global Mills grain elevator.
Klamath Falls, OR
From US-97, take the exit for OR-39 towards Klamath Falls. Turn right at the first traffic signal onto US-97 Bus. Turn right again at the first intersection. Our scrapyard is located on the left side of the street.
From Alturas, CA on route 39: Turn left at the first traffic signal approaching Klamath Falls, then proceed from the light as above.
From Lakeview, OR on route 140: At the second traffic signal approaching Klamath Falls, go straight ahead onto US-97 Bus., then proceed from the light as above.
Laramie, WY
Lewiston, ID
From US-12 make the turn at the car dealership (coming from the East this will be the turn right after you cross the bridge). Follow the route and our facility will be on the right.
Logan, UT
- ⚠️ The directions in this section need verification.
Take exit 362 from I-15 and drive to Logan on US-89. Turn left at 400 No. Avalanche Steel is located on the left side after the truck stop.
Moab, UT
Drive into Moab on US 191. At the intersection just south of the only traffic signal in town, turn east to reach Avalanche Steel.
Pendleton, OR
Take exit 207 (W. Pendleton) from I-84 and turn West towards the industrial area. Take the first left turn. Travel one block and you will see our scrapyard on the left side of the street.
Port Angeles, WA
Portland, OR
Take exit 3 from I-405, turning onto US-30 West towards Astoria. Turn right at the traffic signal at the end of the freeway. Our scrapyard is located on the left side of the street.
Pueblo, CO
From I-25 take exit 97, go West. Turn right at the stop sign, take the next right at Northern Ave. Follow Northern Ave, our facility will be on the left across from Deep Grove.
Rangely, CO
We are located just off of CO-64 on the North part of Rangely, right next to Drake Dealership.
Salem, OR
Take exit 233 (Albany) from I-5 and turn onto US-20 East towards Bend. Turn left before the gas station onto the service road. Travel two blocks and you will see our factory on the left side of the street.
